Completed Jobs by Bock Air Conditioning

May 25, 2026 | Cleburne, TX

Customer called to schedule their routine A/C maintenance service. Upon arrival, we performed a full inspection of the system and found all electrical wiring and connections to be in good condition. We checked the amp draw on the system, and all readings were within normal operating range. The condensate ...

May 25, 2026 | Cleburne, TX

Customer contacted us to schedule a preventative maintenance visit for their A/C system. During the inspection, we checked all electrical wiring and components and found everything operating properly. System amp draw was tested and within manufacturer specifications. We inspected the condensate drain line, which was draining correctly, and verified ...

May 24, 2026 | Fort Worth, TX

Customer called and reported that their mini-split system was leaking water onto the wall. We came out the following morning and serviced all three head units. We flushed and cleared all drain lines, inspected the indoor coils, and washed the outdoor condenser coil. After completing the service, we tested the ...

May 21, 2026 | Burleson, TX

Customer called and reported that their mini-split system was not cooling properly. Upon inspection, we found that the issue was caused by dead batteries in the remote control, preventing the system from operating correctly. We replaced the batteries, tested the system thoroughly, and confirmed that the mini-split is now cooling ...

May 21, 2026 | Burleson, TX

Customer called and reported that the air in the shop was not cooling properly. Upon inspection, we found significant air leakage at the supply plenum, which was causing loss of airflow and reduced cooling performance. We also found that the system only had one return, and the existing return air ...

May 20, 2026 | Crowley, TX

We contacted the customer as part of their maintenance agreement to perform a system inspection. On the downstairs unit, all wiring, safety switches, refrigerant levels, drains, and components checked out good. The drain pan and coil were clean, and we washed the outdoor condenser coil. We then inspected the upstairs ...

May 20, 2026 | Mansfield, TX

Customer requested a routine maintenance service on their system. We inspected all wiring, safety switches, thermostat, and refrigerant levels, and everything checked out good. The indoor coil, blower wheel, and blower assembly were clean and operating properly. We washed the outdoor condenser coil and checked the compressor amp draw, which ...

May 18, 2026 | Garland, TX

Customer had a compressor failure due to burnt-out terminals. We replaced the compressor under warranty and tested the system. Everything is now working great.

May 16, 2026 | Arlington, TX

Customer called and reported that their unit quit working. We went out and found that the capacitor was bad and the condenser fan motor had shorted to ground. We replaced both components and tested the system. Everything is now working perfectly.

May 14, 2026 | Burleson, TX

Customer called and reported that the air conditioning system was not keeping up and the indoor temperature continued to rise. Upon inspection, we found that the system had a bad capacitor and was approximately 2 pounds low on refrigerant. We checked the system thoroughly for leaks but were unable to locate ...

May 11, 2026 | De Soto, TX

Customer called to set up a routine maintenance visit for their A/C system. We checked all electrical components, verified proper amp draw, inspected the drain line, and confirmed the filter was clean. The outdoor condenser coil was cleaned and washed as part of the service. System is operating properly ...

May 8, 2026 | Burleson, TX

Customer called and reported smelling something like burning wires. We went out ASAP and found that the upstairs unit was not cooling properly due to a bad run capacitor and contactor. We replaced both components and tested the system. Everything is now working properly with no unusual smells.

May 7, 2026 | Hurst, TX

Customer scheduled a routine A/C maintenance service with us. We inspected all wiring, checked system amp draw, inspected the drain line, and confirmed the filter was clean. We also washed the outdoor condenser coil to help maintain efficiency. At this time, the system is operating properly with no issues ...

May 7, 2026 | Burleson, TX

Customer contacted us to schedule a preventative maintenance service on their A/C system. We inspected all electrical components, checked amp draw, verified the drain line was operating properly, and confirmed the filter was clean. The indoor coil was inspected and found to be clean, and we washed the outdoor ...

May 5, 2026 | Cleburne, TX

Our technician diagnosed the P6 error code and found the system was going into a low-pressure fault condition. Upon further inspection, we discovered the refrigerant charge was below the proper operating range.