Completed Jobs by Bock Air Conditioning

March 23, 2026 | Fort Worth, TX

We went out there and performed our Spring maintenance and everything was clean and working well!  

March 23, 2026 | Burleson, TX

Performed mini-split startup and corrected error code P6 by replacing a defective pressure switch. System is now running efficiently and performing as it should.

March 23, 2026 | Fort Worth, TX

Installed new 24V wiring from the air handler to the outdoor unit after power was not reaching it. Everything is now running great.

March 23, 2026 | Cleburne, TX

Completed seasonal maintenance and corrected a low capacitor by replacing it. System tested and is now running efficiently.

March 22, 2026 | Burleson, TX

We went out there and found that the wire on the capacitor was burnt. We cut out the bad piece of wire, put on new connectors, and washed the outside unit. Everything is running well and cooling.

March 20, 2026 | Fort Worth, TX

Completed spring AC maintenance and everything looked good. The system is running smoothly and ready for the warmer weather.

March 19, 2026 | Burleson, TX

The customer called because Rooms 2 and 3 were not heating properly. We found the gas valve was not receiving a proper 24-volt signal, and the control board was burned. We replaced both the gas valve and the control board. The unit is now heating properly.

March 19, 2026 | Joshua, TX

Went out there and found a loose reversing valve coil plug causing the noise. Secured the connection, and the system is now cooling and running great.

February 26, 2026 | Burleson, TX

The customer called because the kitchen unit was not keeping up and the temperature inside was rising. We inspected the system and found the refrigerant charge and capacitor were both in good condition. The outdoor condenser was heavily soiled, so we cleaned it thoroughly. After cleaning, the system was operating ...

February 9, 2026 | Arlington, TX

The customer called us to replace all of the building's air filters and perform a system check. We replaced all filters, inspected the equipment, and confirmed everything is operating properly. The systems are running as they should.

February 9, 2026 | Cedar Hill, TX

The customer called because the middle unit at the building was not operating. We found the display board was stuck on a "New Device Added" message and would not allow us to scroll through the menu. After troubleshooting with the manufacturer's technical support, it was confirmed that the display board ...

January 30, 2026 | Burleson, TX

Upon inspection, we found the unit was not receiving proper high voltage. The breaker was not tripped but was not supplying power. Reset the breaker, and the system resumed normal operation.

January 26, 2026 | Fort Worth, TX

Performed first maintenance visit. Checked refrigerant (Freon) levels, inspected capacitor, verified proper cycling time, and tested emergency heat. All components were operating properly. Washed outdoor unit and replaced air filter.

January 25, 2026 | Burleson, TX

The customer called us because they thought their heater was not working. We were able to determine that they had dirty filters and needed a new capacitor.  They were thrilled that the house was warm afterwards.

January 23, 2026 | Fort Worth, TX

Arrived onsite and completed full duct cleaning service, including supply vents and AC system. Ductwork and system were sanitized for improved air quality.